TECB242 - 4.2 Tonne 2 Post Base Plate Hoist

The Tecalemit two post vehicle hoist is designed with the professional mechanic in mind. 

With a 4.2 tonne lifting capacity and featuring an asymmetrical design, the hoist easily caters for a wide range of vehicles from small passenger cars, light commercial, low clearance and off road recreational vehicles. 

The TECB242 utilises a number of safety features in its design. The hoist is equipped with a pre-set loading limit to avoid overloading and an Aluminium motor to protect from heat damage.

The Hoist Features:

• Aluminium motor to avoid heat damage.

• Pre-set loading limit to avoid overloading.

• Adjustable lifting pads with a minimum height of 90mm.

• Pick up pad extenders to increase the pad height, ideal for off-road vehicles.

• Two stage long and three stage short lifting arms.

• Inside width suitable for SUV and wide vehicles.

• Door protection rubber pad.

• Integrated pick up pad holders.

• Foot protection.

• Compliance with Australian Standard AS1418.9:1996.

Technical Specifications.

• Lifting Capacity: 4200kg

• Maximum Lift Height: 1880mm

• Minimum Pad Height: 90mm

• Inside Column Width: 2850mm

• Electric Motor: 3 Phase 415V

• Lifting Time: 50 seconds

• Minimum Concrete Thickness*: ≥120mm 20,7MPa Reinforced

• Recommended Anchor Bolt: Ramset TruBolt M16x125

• Drill Hole Diameter: 16mm

• Drill Hole Depth: 100mm

• Tightening Torque: 150Nm

Optional Extras

• 240V Single Phase electric motor.

Spare Parts Support

Tecalemit stock a comprehensive supply of spare parts for all our hoists to ensure minimal downtime.

With experienced staff on-hand to offer technical advice on all aspects, from hoist selection, installation, operation and on-going service and maintenance.

*NOTE: The lift should be installed on a smooth and solid concrete surface with its strength more than 3000psi (20.7MPa) with a minimum thickness of 120mm.